Eaton Power Xpert 9395P-1100/1100, Инструкция по установке и эксплуатации, Страница: 77 / 214

Eaton ® Power Xpert ® 9395P-1200 Installation and Operation Manual 164000500—Rev 11 59
the top rear and top front of the ISBM and UPM sections. Secure the brackets with the screws from the
hardware kit (see
Figure 23 ).
12. Locate one flat bracket and screws from the hardware kit. Align the holes in the flat bracket over holes in
the front base of the ISBM and UPM sections. Secure the bracket with the screws from the hardware kit
(see ).
Figure 23
13. Proceed to paragraph 4.4 Electrically Connecting the Sections .
Figure 23. ISBM Section to UPM Section Joining Brackets
Front View Base Bracket
UPM Section Base
ISBM Section Base
Bracket from Kit
Screw from Kit Screw from Kit
Top View Rear Bracket
UPM
Section Top
ISBM
Section Top
Screw from Kit Screw from Kit
Bracket from Kit
Back
Top View Front Bracket
UPM
Section Top
Screw from Kit Screw from Kit
ISBM
Section Top
Bracket from Kit
Front
44..44 EElleeccttrriiccaallllyy C Coonnnneeccttiinngg tthhee S Seeccttiioonnss
1. Unfasten the front door latch and swing the door open (see Figure 17 ).
2. Remove the door. Remove the retaining screw located inside the door at the bottom hinge pivot point,
then lift the door off. Retain the hardware for later use.
3. Remove the screws securing the ISBM section right bottom internal safety shield panel and remove the
panel to gain access to the internal input, output, and battery terminals. Retain the hardware for later use.
NOTE AC and DC input intercabinet power wiring harnesses are supplied coiled and secured in
the UPM wireway on the left side of the UPM section (see
Figure 24 )
4. Locate the AC and DC input intercabinet power wiring harnesses (long cables labeled xG1, xG2, and xG3).
Remove wire ties as necessary and uncoil the cables.
UPS System Installation