Eaton Power Xpert 9395P-1100/1100, Инструкция по установке и эксплуатации, Страница: 63 / 214

Eaton ® Power Xpert ® 9395P-1200 Installation and Operation Manual 164000500—Rev 11 45
Table 25. Recommended DC Input Battery Disconnect Ratings – Common Battery
UPS Model
Input Rating for Each UPM
480V/415V/400V/380V
Eaton 9395P-1200/1200
Eaton 9395P-1200/1100
Eaton 9395P-1200/1000
3000A
Eaton 9395P-1200/900
Eaton 9395P-1200/825
2500A
Eaton 9395P-1200/750
Eaton 9395P-1200/675
2000A
Table 26. Recommended DC Input Battery Disconnect Ratings – Separate Battery
UPS Model
Input Rating for Each UPM
480V 480V/415V/400V/380V
Eaton 9395P-1200/1200
Eaton 9395P-1200/1100
Eaton 9395P-1200/1000
Eaton 9395P-1200/900
Eaton 9395P-1200/825
Eaton 9395P-1200/750
Eaton 9395P-1200/675
800A 700A
33..22..55 U UP PS S S Syysstteem m IInntteerrffaaccee W Wiirriinngg P Prreeppaarraattiioonn
Control wiring for features and options should be connected at the customer interface terminal blocks located
inside the UPS.
Do not directly connect relay contacts to the mains related circuits. Reinforced insulation to the mains is
required.
AVERTISSEMENT!
Ne pas directement brancher les contacts de relais aux circuits du réseau. Une isolation renforcée des réseaux
est nécessaire.
Read and understand the following notes while planning and performing the installation:
• Use Class 1 wiring methods (as defined by the NEC) for interface wiring from 30V to 600V. The wire
should be rated at 600V, 1A minimum and 12 AWG maximum.
• Use Class 2 wiring methods (as defined by the NEC) for interface wiring up to 30V. The wire should be
rated at 24V, 1A minimum. When Class 2 circuit wiring must be mixed with Class 1 wiring, use Class 1
wire and wiring methods.
• Use shielded twisted-pair wires for each input and return or common.
• All interface wiring and conduit is to be provided by the customer.
UPS Installation Plan and Unpacking