Eaton Power Xpert 9395P-1100/1100, Инструкция по установке и эксплуатации, Страница: 126 / 214

108 Eaton ® Power Xpert ® 9395P-1200 Installation and Operation Manual 164000500—Rev 11
5. Reinstall the conduit landing plate.
6. Install conduit between the UPS and SCM II. See Figure 61 for SCM II knockout hole location.
7. Install wiring between the UPS and SCM II. See Figure 49 and Table 29 for the Powerware Hot Sync CAN
Bridge Card terminal location and wiring information, and Figure 57 , Figure 55 , and Table 33 for the SCM II
terminal location and wiring information.
NOTE 120 Vac for the SCM II should be supplied from the critical bus by facility planners or the
customer.
8. Install 120 Vac power wiring from the critical bus to the SCM II. See Figure 57 , Figure 55 , and Table 33 for
the terminal location and wiring information.
Figure 57. Supervisory Contact Module II Terminal Location.
Ground
Terminal
Terminal TB1 Signal
Connections from the UPS
Terminal TB3
120 Vac Power
Terminal TB2 Customer
Supervisory Contact Interface
NOTE Setup of the Powerware Hot Sync CAN Bridge Card must be performed by an
authorized Eaton Customer Service Engineer. Contact an Eaton service representative
to schedule a date.
9. Install wiring between the SCM II terminal block TB2 and the monitoring equipment. See Figure 57 for
terminal block location and Figure 58 for terminal assignments.
10. Close the front door and secure the latch.
Installing Options and Accessories