Eaton Power Xpert 9395C, Инструкция по установке и эксплуатации

Страница: 21 / 175

4 Eaton Power Xpert 9395C UPS Installation and Operation Manual 164000821—Rev 06
11..22..66 M Moonniittoorriinngg aanndd C Coom mm muunniiccaattiioonn
The UPS system can be further enhanced by adding optional accessories such as a Remote Emergency Power-
off (REPO) control, RMP II, SCM II, RIM II, or X-Slot communication cards. See
Chapter 5 Installing Options and Accessories for additional information.
• Remote Monitor Panel II (RMP II) – An optional RMP II contains backlit status indicators and a local horn,
allowing monitoring of the operational status and alarm condition of the UPS from virtually any location
within the facility.
• Relay Interface Module II (RIM II) – An optional RIM II uses relay contact closures to indicate the UPS
operating status and alarm condition.
• Supervisory Contact Module II (SCM II) – An optional SCM II establishes an interface between the UPS
system equipment and the customer's monitor.
• X-Slot Cards – Optional X-Slot cards support several protocols, such as SNMP, HTTP, IBM AS/400, and
Modbus.
• PredictPulse™ Remote Monitoring and Management Service – PredictPulse is a subscription
monitoring and management service from Eaton that collects and analyzes data from connected power
infrastructure devices, providing us with the insight needed to make recommendations and take action on
your behalf. It’s also powered by CA Technologies, bringing together the best in hardware and software.
Like a second set of eyes on your power infrastructure, PredictPulse provides 24/7 remote monitoring of
alarms and system performance (load, temperature/humidity, battery health, energy savings and service
level) to reduce downtime risk and expedite repairs. PredictPulse also shares real-time status and trend
information via an online dashboard and smartphone mobile app (Apple and Android), giving subscribers
insights about past and current performance, a list of all active alarms, and asset management data (i.e.,
battery date codes, last and next scheduled service dates, firmware versions). The service notifies
customers of critical alarms, supports remote diagnostics, and facilitates smart dispatch of technicians.
PredictPulse requires a Power Xpert
®
Gateway Card (PXGX) connectivity card in an X-Slot communication
bay and an Environmental Monitoring Probe (EMP) for battery temperature/humidity monitoring.
See Chapter 8 Communication for additional information on monitoring and communication features.
11..33 B Baatttteerryy S Syysstteem m
Although not provided with the UPS, a battery system is required to provide emergency short-term backup
power to safeguard operation during brownouts, blackouts, and other power interruptions. The battery system
should be equipped with lead-acid batteries. An external battery disconnect switch must be used.
UPSs in distributed bypass and parallel systems must use a separate battery system.
See the battery related documents located in the system manual for battery cabinet specifics.
11..44 U Ussiinngg TThhiiss M Maannuuaall
This manual describes how to install and operate the Eaton 9395C UPS. Read and understand the procedures
described in this manual to ensure trouble-free installation and operation. In particular, be thoroughly familiar
with the REPO procedure (see paragraph
7.4.2 Using the Remote Emergency Power-off Switch and
7.5.8 Using the Remote Emergency Power-off Switch ).
The information in this manual is divided into sections and chapters. The system, options, and accessories
being installed dictate which parts of this manual should be read. At a minimum, Chapters 1 through 4 and
Chapter 7 should be examined.
Read through each procedure before beginning the procedure. Perform only those procedures that apply to the
UPS system being installed or operated.
Introduction