Eaton PDI WaveStar, Руководство по установке и эксплуатации

Страница: 53 / 68

Eaton PDI WaveStar Color Monitor Setup and Operation Manual P-164001109—Rev 01 43
Table 8. Panelboard Alarms
Alarm Alarm Description
Over Current PB Current feeding one panelboard is above alarm threshold.
Under Current PB Current feeding one panelboard is below alarm threshold.
Over Curr both PBs A common circuit feeding both panelboards is over alarm threshold.
Under Curr both PBs A common circuit feeding both panelboards is under alarm threshold.
Over Volt Main Over voltage measured on main voltage source to panelboard.
Under Volt Main Under voltage measured on main voltage source to panelboard.
Over Volt Alt Over voltage measured on alternate voltage source to panelboard.
Under Volt Alt Under voltage measured on alternate voltage source to panelboard.
77..33..55 C Ciirrccuuiitt B Brreeaakkeerr S Sttaattuuss B Booaarrdd A Allaarrm mss
Table 9. CB Status Board Alarms
Alarm Alarm Description
Circuit Breaker N Open Circuit Breaker has opened.
Circuit Breaker N Tripped Circuit Breaker has tripped.
77..44 TTrroouubblleesshhoooottiinngg
Table 10. Troubleshooting Guide
Symptom Probable Cause Remedy
Touch Screen does not respond to touch. The object on the touch screen was not
touched long enough. The touch screen is set up so that an
object must be pushed firmly for a
moment. A quick "peck" with a finger or
stylus may not be registered.
Monitor hangs: Monitor is locked up and
there is no response to touches. Press RESET button on backpanel.
No power to unit. Main unit is not powered up. Plug is not
seated in J5 or J6 of the Monitor’s
backpanel. Backlight turned off. Turn on or reset main circuit breaker to
the Monitor. Re-seat Monitor backpanel
power plugs J5 (120 VAC) or J6 (24 VDC).
Touch the screen anywhere to turn the
backlight on.
Monitor has communication errors. Open connection or lose wire on the
Modbus chain. Display may not be
properly setup. Check wiring. Refer to "Modbus" AND
"Setup" previously in this manual. Refer
to initial setup to setup downstream
units. Go to the Setup screen and press
RESTART WITH NEW SETTINGS to force
the display to search for downstream
devices.
Alarms and Troubleshooting