Eaton PDI WaveStar, Руководство по установке и эксплуатации

Страница: 40 / 68

30 Eaton PDI WaveStar Color Monitor Setup and Operation Manual P-164001109—Rev 01
Figure 24. Readings: Enhanced Subfeeds (ESF) (Part 2)
NO : Subfeed circuit by number and phase
Instantaneous measurements by phase:
% LOAD:
%Load is a percent of the Full Load
amperage for this breaker; “Full Load” is a
user-specified percent of breaker size, given in
Modbus register 494 (“Full Load Percentage”) in
the ESF Points List.
CREST FACTOR : Peak current/RMS current
%THD : Total Harmonic Distortion as percent
Measurements and alarms:
NO : Circuit by number and phase
AMPS : Instantaneous current in Amperes (A)
CB
: Circuit breaker rating (A)
MIN
: Minimum current read (A) after first registering
minimum current
MAX : Maximum current read (A)
ZERO : OK = Current has not read 0 after registering a
current; ACTIVE = Current has read 0 after registering
a current.
WARNING
: OK = No warnings outstanding for this
circuit; ACTIVE = warning outstanding.
ALARM : OK = No warnings outstanding for this
circuit; ACTIVE = alarm outstanding
Instantaneous measurements:
Voltage
Frequency
66..33 B BC CM MS S ((N Noorrm maall)) P Paanneellbbooaarrdd R Reeaaddiinnggss
BCMS Normal points list allows customization of thresholds and alarm level for each individual circuit, which is
done in BCMS setup, not in the Color Monitor. KWH Power measurements are available only for panelboard
totals. See , "Readings: BCMS Normal".
Device Chain: Readings