Eaton PDI WaveStar TFA STS 250-600A, Инструкция по установке и эксплуатации

Страница: 121 / 150

Eaton PDI WaveStar TFA Static Transfer Switch Installation and Operation Manual P-164001113—Rev 01 107
C Chhaapptteerr 1155 O Oppeerraattoorr P Prroocceedduurreess
Once configured, the STS requires few operator interventions. The following procedures cover the main
interventions.
1155..11 N Noorrm maall S Sttaarrttuupp
Powering up the STS for normal operation can be done as follows:
1. The STS should be left in Normal mode configuration for MCSWs as shown in Figure 7 , Normal Mode
MCSW Configuration.
2. Apply power to the STS externally by closing circuit breakers feeding the unit.
1155..22 S Sttaarrttuupp aafftteerr P Poow weerr R Reew woorrkk
Initial startup is covered in paragraph 6.1 Commissioning: Initial Power-up Site Test . If power rework has been
performed upstream of the STS, follow steps 2-4 of this procedure to verify correct input power to the STS.
1155..33 R Reessttaarrttiinngg tthhee M Moonniittoorr
When the Ethernet settings are changed on the Settings screen ( 11.2 Ethernet ), the Monitor must be
restarted. Because the Monitor logic controls transfers, the STS must briefly be put in Redundant Mode to
provide a backup transfer capability to the Monitor:
1. On the Home screen, make note of the existing parameters, particularly Preferred Source and the actively
conducting source as indicating by the yellow line on the One-line display.
2. Use the ROI panel key to open the ROI panel.
3. On the ROI, set the MODE OF OPERATION toggle switch to REDUNDANT mode.
4. Login on the Home page as Administrator or other higher-level authorization.
5. In the navigation buttons, touch the Setup button to display the Settings screen.
6. In the Ethernet Settings panel, touch the Restart button to restart the Monitor. Touch the button just
once: the restart will take around 30-45 seconds and it is not immediately apparent that the restart is
proceeding.
7. When the Home screen reappears, do a visual check of Monitor parameters and settings for correctness:
a. On the dynamic One-line display, verify that the currently conducting source matches the source
indicated by yellow line.
b. Verify that the Preferred Source selector is selecting the currently conducting source. (If the
Preferred Source selector is not the current source, it will force a transfer when you return to
NORMAL mode.)
c. If the Preferred Source is not the currently conducting source, login on the Home screen with at
least operator-level authorization and set the Preferred Source selector to the source recorded in step
1.
8. After validating the Monitor, at the ROI set the MODE OF OPERATION toggle switch to NORMAL mode.
9. Close and lock the ROI panel.
1155..44 S SA AS S B Booaarrdd TTrraannssffeerrss
If the Monitor fails to transfer the load, the SAS board will take over the transfer. If Alarms appear showing the
SAS board in control, follow these steps:
1. Check the Alarms page for alarms showing the SAS board is in control.