Effective May 2018
Supersedes 66720 12/93
Instruction Sheet
IL211008EN
Optimedia®
Periodical Shelf
Please read these instructions carefully and follow
the installation steps in sequence.
The periodical shelf must be located a specific
distance above the nearest component or media
below it. The periodical shelf may be used in
conjunction with a stationary shelf.
1. Locate the slots in the uprights for mounting the
two end brackets (see Figure 1).
Make sure all
the slots are at the same level.
Use the counting
holes in the uprights as a guide when counting
slots for spacing.
Note: all the slots are
1
/
4
" apart;
the counting holes are 2" apart.
2. Starting at either side of the cabinet, hold an end
bracket horizontally and insert its two offset tabs
into the slots in the uprights (see Figure 2). Then
let it pivot downward and hang vertically. Install the
other end bracket the same way.
3. Next install the periodical shelf (see Figure 3).
Hold the shelf horizontally between the two end
brackets, above the bumpers. Retract the L.H.
pivot pin on the shelf and insert the R.H. pivot pin
into the plastic busing in the R.H. end bracket.
Then release the LH. pivot pin into the plastic
bushing in the L.H. end bracket. Rotate the front of
the shelf down until it rests against the bumpers.
Figure 2
Figure 3
Figure 1
Periodical shelf
Slots in the
uprights
Slots in the
uprights
R.H. End
bracket
R.H. End
bracket
R.H. pivot
pin
Plastic
Bushing
Bumper
Offset tabs
Periodical
shelf
Counting holes
12.75"
(51 slots)
Top of shelf
or nearest
component or
media
