5 Display
5.3 Order of displays
NZM-XMC Measuring and Communication Module
11/16 MN01219001Z-EN
www.eaton.com
41
•
The next display shows the phase-related power factor (p.f.).
•
This is followed by information on power as well as inductive and
capacitive reactive power.
•
The third display shows the relevant information on reactive power.
•
The last display shows the values PD (power direction), frequency, and
PF (power factor). Further pressing of the arrow button starts a new
display cycle.
5.3.1 Showing different energy types
Holding down the arrow pushbutton actuator for two seconds moves the
display of line 4 between the different energy types (active, reactive and
apparent). Press the arrow pushbutton actuator for two seconds to move to
the next energy type.
Figure 21: Order of the different energy types displayed
5.3.2 Display maximum and minimum values
Pressing the max. and min. pushbutton actuators will display the maximum
and minimum values for the current screen. The relevant display texts will
flash.
5.3.3 Deleting maximum and minimum values
To clear the indicated maximum and minimum values, press the “max” and
“min” keys at the same time. To toggle between the options “yes” and
“no” (
Figure 22), use the “max” key.
Figure 22: Deleting maximum and minimum values
If the display shows “yes” on the bottom line, pressing the arrow key will
delete the value and cause the display to switch to the next display:
the power values.
Pressing the arrow key enables you to delete the power values as well.
The max button can be used to toggle between “yes” and “no”.
