Eaton M-Max series, Руководство по эксплуатации

Страница: 73 / 199

04/10 MN04020001Z-EN
Control unit
69
Setting parameters
The following table shows a good example of the general
execution for selecting and setting parameters.
h When the MMX is switched on for the first time, it
activates the Quickstart Wizard to guide you through
specific parameters
(
A
as per “Step” 2).
Sequen
ce Commands Display Description
0 Measured value 1.1
The display changes automatically with the value of the output
frequency 0.00 Hz (at STOP).
1 By actuating the BACK/RESET button, you activate the menu level
(arrow flashes).
The two arrow buttons enable you to select the individual main
menus:
• REF = Setpoint input (Reference)
• MON = Operational data indicator (Monitor)
• PAR =Parameter levels
• FLT = Fault log (Fault).
Use the OK button to open the selected main menu.
2 The numerical first value is always shown from the selected main
menu.
Example: Main menu PAR, Parameter P1.1
The display automatically switches between the parameter number
and the defined value.
P1.1 =1 is displayed at the first switch on and after the factory
settings have been activated.
L
Display in automatic alternation
M
Use the OK button to activate the selected parameter.
The value (1) flashes.
P1.1 =1:
• The Quickstart Wizard is activated and guides you step-by-step
through the specific drive parameters ( a page 72).
RUN STOP ALARM FAULT READY
REF
FWD REV I/O KEYPAD BUS
MON
PAR
FLT
BACK
RESET
RUN STOP ALARM FAULT READY
REF
FWD REV I/O KEYPAD BUS
MON
PAR
FLT
OK
RUN STOP ALARM FAULT READY
REF
FWD REV I/O KEYPAD BUS
MON
PAR
FLT
OK
RUN STOP ALARM FAULT READY
REF
FWD REV I/O KEYPAD BUS
MON
PAR
FLT