Eaton i-on30EX, Руководство по установке

Страница: 19 / 44

i-on30EX/EXD
Page 15
3. Installation
Note: The installation steps listed below assume
that you have already decided on the required
number and location for all keypads, expanders
and power supplies.
Caution: Static Electricity
Like many other electronic products, the control
unit, keypads and expanders contain components
that are sensitive to static electricity. Try not to
handle their PCBs directly. If you must handle a
PCB, take the standard precautions against
damage by static electricity.
Step 1. Fit the Control Unit
Case
Fitting
To prevent access to the inside of the control unit
through the holes in the rear of the case you must
mount the control unit on a wall or other flat
surface.
Mount the case vertically, as shown in Figure 1.
Use all three fixing holes. Use No8/M4 dome or
pan head screws at least 30mm long, inserted into
wall anchors appropriate for the type of wall.
Figure 1 shows the fixing holes and cable entries.
Protect the unit from dust and drilling debris when
drilling the fixing holes.
Step 2. Run Bus Cable
Please read “Cabling Requirements on page 12.
Step 3. Fit and Connect the
Keypad(s)
Siting the Keypad(s)
Do site the keypad(s):
Within the area protected by the alarm
system.
At a convenient height and location for the
user.
Out of sight of potential intruders.
Do NOT site the keypad(s):
Next to electronic equipment, particularly
computers, photocopiers or other radio
equipment, CAT 5 data lines or industrial
mains equipment.
Where the cable run from the control unit will
be longer than 100m (see Cable
Configuration and Length).
Note: Do not fit any keypad with an internal prox
reader closer than one meter to any other type of
prox reader. This includes other keypads with
prox readers, external prox readers such as the
KEY-EP, or prox readers used by other systems
(for example access control systems). If you
mount prox readers closer together than one
meter (including on the other side of walls) then
the two prox readers will interfere and may not
work correctly.
Fitting Keypads
Select which cable entry you are going to use and
break out the appropriate plastic sections.
Use 4mm x 25mm countersunk screws with a
thread suitable for the wall material in at least
three fixing holes when mounting the back of the
keypad on the wall.
i-KP01
For i-KP01 keypads on Grade 3 systems drill out
the hole for the back tamper using a 7mm bit (see
Figure 19).
Figure 19 Screw i-KP01 Back Box to Wall
KEY-K01/KP01/KPZ01
Make sure the backplate is level and mark, drill
and plug at least three fixing holes. Screw the
backplate to the wall through the fixing holes
using the M4 screws.
Figure 20 Screw KEY-K01/KEY-KPZ01 Back Box
to Wall