Flexi -3G Installation & Commissioning Manual
Chapter 3. Installation Procedure
Document No: - 4493-CM-EN-10989402
Page 25 of 94
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
3.3.2. Fitting the Rear Panel
1
Side Panel LH
2
Side Panel RH
3 Rear Panel
13 Screw M5x10 PH Pozi
16 Washer Wavy M5
Fig. 3-3 Fitting the Rear Panel
1.
Put the Rear Panel in position, as shown, aligning the tabs of the Rear Panel with the slots in the
Side Panels.
2.
Insert the tabs of the Rear Panel into the slots in the Side Panels.
3.
Push the rear panel down until the tabs on the Rear Panel bottoms on the slot in the Side Panel.
4.
Secure the Rear Panel to the Side Panels, using a Screw M5x10 PH Pozi and M5 Washer Wavy in
10 positions.
5.
Tighten the Rear Panel Fixings to a torque of 2.9Nm.
1
2
3
2
3
13
16
