Changing parameters
For more information visit:
www.EatonElectrical.com
MN05013005E
365
EZD will now show the new menu language.
Press
ESC
to return to the Status display.
Changing parameters
EZD allows you to change function relay parameters such as
timing relay setpoint values and counter setpoints without
having to call up the circuit diagram. This is possible
regardless of whether EZD is running a program or is in STOP
mode.
X
Press
OK
to switch to the main menu.
X
Start the parameter display by selecting PARAMETERS.
All function blocks are displayed as a list.
The following preconditions must be fulfilled in order for a
parameter set to be displayed:
• A function relay must have been included in the circuit
diagram.
• The PARAMETERS menu must be available.
• The parameter set must have been enabled for access,
indicated by the + character at the bottom right of the
display.
SICUREZZA...
SISTEMA...
LINGUA MENU...
CONFIGURATORE...
T 03 Ü S
+
CP08
-
C 17
+
L: 1
RUN
J
Parameter sets can only be enabled or protected via the
FUNCTION RELAYS menu, or via the circuit diagram with
the “+” enable and with “–” inhibit parameter set characters.