For more information visit:
www.EatonElectrical.com
Programming wiring
MN05013005E
150
The function block is deleted.
Checking function blocks
You can check function blocks in the same way as circuit
diagrams. The device is in RUN mode.
Checking from the circuit diagram:
Position the cursor on a contact or a coil of the required
function block. Press
OK
.
The function block will be displayed, in this case a timing relay.
• >I1= set time of the timing relay,
• QV> = the actual value is 14 minutes 42 seconds,
• The enable coil is actuated, EN is visible.
If a coil of a function block is actuated in RUN mode, the coil
name with the coil designation will appear on the display.
Checking the function block via the function block editor:
You access the function block list via the FUNCTION
RELAYS menu.
Select the required function block:
In this case the arithmetic function block AR01 in the Adder
mode.
X
Press the
OK
button.
The function block is presented with the actual values and the
result.
Displaying the operands when checking the function
blocks:
If you want to know which operands are used on the function
block inputs and outputs when checking the function block,
press the
ALT
button on the displayed value.
AR
01 ADD
+
T 18 ?X
-
L:001
T 01 X? M:S +
>I1 20:30
>I2
QV> 14:42
.. EN..
AR
01 ADD
+
CP10
+
T 18 ?X
-
L:001 RUN
AR01 ADD
+
>I1
20056
>I2 1095
QV> 21151
