Eaton Expertline, Техническое руководство, Страница: 5 / 32

5
Expertline LED Beacon Technical Manual
EXPERTLINE LED BEACON TECHNICAL MANUAL
TMF0056.A www.eaton.com
Connecting
Open the terminal room on the underside of the Ex-LED Light. Lay the connecting cable through the cable gland, secure
the connecting cable using the cable gland nut and arrange the conductor ends (see drawing on page 10).
The Ex-LED Light Expertline LED comes in a direct current 24 V
DC
version and in an alternating current 230 V
AC
version. In
the case of the direct current version, please observe the polarity of the connections. For the alternating current version,
the cable ends can be randomly connected. Then close the terminal room with the terminal room lid. The screw torque is
0.9 … 1.1 Nm.
Notes on cable gland and cable entry
The cable glands must meet the requirements of protection against explosive atmospheres, temperature range -40°C
≤ Ta ≤ +70°C and IP degree of protection IP66. Use only suited tools for connecting the cable and installing the cable
gland! The cable gland is suited for permanent wiring only. In case of factory fitted cable glands the attached operating
instructions have to be considered.
Service
No maintenance required.
Commissioning
After having been connected to the mains, the signalling light is operational. Start operating with closed housing only.
Operating utilization position
Any
Care and maintenance
The signalling light contains no serviceable parts. The requirements of EN 60079-17 regarding the regular control of the
explosion protection must be applied.
CE symbol
We hereby declare this product is in compliance with the Essential Health and Safety Requirements of
ATEX Directive 2014/34/EU,
EMC Directive 2014/30/EU,
Low Voltage Directive 2014/35/EU
and RoHS Directive 2011/65/EU.
The appropriate standards, technical regulations und specifications you can take from the attached conformity declaration
and the conformity declarations on our Website.