Eaton easyControl EC4-200, Руководство пользователя

Страница: 70 / 113

Connection setup PC – EC4-200
10/10 MN05003003Z-EN
66
Scan/Modify the IP address
The “setipconfig” and “getipconfig” browser commands are
available for modifying and scanning the IP address
a
section
“Browser commands” on page 59.
Restart the PLC after you have changed the IP address. Ensure that
the IP address of the programming device belongs to the same
address family. In other words the IP address of the programming
device and the PLC must correspond in the following figure groups
with a subnet mask of 255.255.255.0:
Example 1
IP address PLC: 192,168,119xxx
IP address PC: 192,168,119yyy
Example 2
IP address PLC: 192,168,100xxx
IP address PC: 192,168,100yyy
The following conditions apply in example 1 and 2:
• xxx is not equal to yyy
• the addresses must be between the limits 1 and 254.
• The addresses must be part of the same address family.
If a connection is not established, the transfer route can be
checked with the “PING” function in order to ensure that the
connection has not failed due to a fault on the transmission path.
The following steps are necessary:
X
Open the DOS window via the “Start” field and the “Run”
command.
X
Enter “CMD” in the input field and confirm with “OK”.
You are presented with a window indicating a drive and a flashing
cursor behind the drive designator.
X
For the example mentioned you would enter the following text:
“ping 192.168.119.60” and confirm this with “OK”.
If the routing is functioning correctly, you will receive a response
indicating the response time. Otherwise a time-out will indicate
problems with the connection setup.
The following figure indicates the result of a correct connection
set-up.
Figure 81: PING response with a correctly established Ethernet
connection