Eaton EASY-RTD-DC-43-03B1-00, Руководство пользователя

Страница: 49 / 91

5. Commissioning
5.1 Initial commissioning
5. Commissioning
When the easy-RTDs are used as intended, they will often be installed in a machine
or system to function as controls and will be wired accordingly.
In this case, the easy-RTDs will need to be switched on and off using the cor-
responding machine controller.
DANGER!
Electric shock hazard!
When setting up and testing the visualization interface, make sure to
use a test environment that is fused as per the state of the art and in
accordance with all applicable standards in order to power the
devices.
The easy-RTD will boot up as soon as it is energized.
If the easy-RTD will not start, or if an error message appears, consult the → Section
"Faults", page 77 section.
The easy-RTD will be shut down as soon as it is not being powered.
CAUTION
SHORT-CIRCUIT HAZARD
If the Resistive-Touch display is or has been exposed to envir-
onmental fluctuations (ambient temperature, air humidity), con-
densation may form on or inside easy-RTD. As long as this
condensation is present, there will be a short-circuit hazard.
Do not switch on the device when it has condensation in or on it.
If the Resistive-Touch display has condensation in or on it, or if it has
been exposed to environmental fluctuations, let the easy-RTD settle
into the existing ambient temperature before switching it on. Do not
expose the device to direct thermal radiation from heating appli-
ances.
Power the easy-RTD with 24 VDC.
The unit will boot up. As soon as the easy-RTD operating system loads, the remote
touch display application will start.
5.1 Initial commissioning
During initial commissioning, as well as after resetting the device to factory settings,
you will need to define the passwords for three types of user:
l
Watch,
l
Operate
easy Remote Touch display 06/21 MN048027EN Eaton.com
49