16
Programming
DPCT IOM InsTruCTIOn OPeraTIOn Manual
MN124018EN January 2023 www.eaton.com
5.4.19 Screen brightness
The screen brightness can be adjusted in 20% intervals.
5.4.20 Welcome screen
When enabled, the welcome screen will appear each time
that the controller is energized.
5.4.21 Screen lock
When enabled and following thirty (30) minutes of inactivity,
the user interface touch screen will lock in order to minimize
accidental inputs. This feature will not inhibit the normal
operation of the controller. To unlock the display, the user
will be prompted to enter in “DPCT”.
5.4.22 Customer service contact
Allows the user to program specific contact information
such as: the company name, contact person, phone
number, and email address. This menu item will allow the
programming of a password, separate from the menu
password to protect this information from alterations. This
information will be shown in the HELP tab under Service
Contact Information.
The service company can also set specific service message
triggers to alert the end user that servicing is required. These
notifications will show in the notification area on the HOME tab.
5.4.22.1 Save configuration
Downloads a master configuration file. A simplified
controller’s configuration can be saved onto a USB drive.
The configuration can then be used on other controllers that
require the same configuration setup. The configuration will
not adjust functionality settings.
5.4.22.2 Load configuration
Loads the master configuration file. A configuration file
will be uploaded to the controller from a USB drive. The
data located in the configuration file will change specific
programmed setpoints in the controller.
5.4.23 Update firmware
If required, firmware can be updated using this menu item.
Firmware needs to be obtained from the factory and will
only be given to authorized service representatives.
5.4.24 Update languages
If required, languages can be updated using this menu item.
A language file needs to be obtained from the factory and
will only be given to authorized service representatives.
5.5 Help tab
Refer to Appendix D for the menu structure of the Help tab
5.5.1 Product manual
A scannable QR code will be generated on screen to allow
the user to download the Instruction and Operation Manual
(IOM) onto a mobile device.
5.5.2 Service contact information
The contact information for the Customer Service Contact
will be shown on this screen.
5.5.3 Factory contact information
The contact information for the factory will be shown on
this screen.
5.6 Pressure settings tab
Refer to Appendix E for the menu structure of the Pressure
Settings tab
5.6.1 Start pressure
The value programmed determines at which pressure the
controller will initiate a crank cycle in AUTO mode. The
controller will start the pump when the measured pressure
is equal to or less than this setting.
5.6.2 Stop pressure
Should the controller be programmed for automatic
shutdown, the value programmed determines the system
pressure must be reached before the controller will
automatically stop the fire pump engine in combination with
the MRT elapsing. If the system pressure does not exceed
the programmed Stop Pressure setpoint, the fire pump
engine will continue to run.
5.6.3 Stop mode
The STOP mode is user selectable; factory DISABLED. If the
STOP mode is DISABLED, the pump engine must be stopped
via the local STOP pushbutton or turning the controller to
the OFF mode whether or not the engine was started via
an automatic start. If the STOP mode is ENABLED, the
controller will stop the pump engine automatically after all
starting conditions have returned to normal (stop pressure
has been met) and the MRT has elapsed.
5.6.4 Start above pressure
The value programmed determines at which pressure the
controller will initiate a crank cycle. The controller will start
the pump when the pressure is equal to or greater than
this setting.
5.6.5 Pressure variance recording
A pressure setting may be selected, such that any change in
pressure greater than this setting, will record the pressure
fluctuation in the controller’s history.
