Eaton DIN500AC, Руководство для продвинутых пользователей

Страница: 14 / 69

Eaton Din Rail UPS Advanced User Guide 9340DC—Rev A 11
C Chhaapptteerr 44 O Oppeerraattiioonn
44..11 P Poow weerriinngg tthhee U UP PS S O Onn
1. Ensure that the UPS input and output wiring are connected and that the correct voltage is being supplied
to the UPS. Press the power ON/OFF button on the front of the UPS for three seconds. The LED’s on the
UPS will turn on. The UPS will then enter normal operation mode and the AC Input Normal Indicator will
remain lit solid green.
2. Check the UPS front panel to verify that there are no active faults. Do not proceed until all active faults are
cleared.
44..22 U UP PS S S Seellff TTeesstt
The UPS self test feature is preformed automatically when the UPS has access to acceptable line voltage. To
Initiate a UPS self test press the On/Off button for less than one second to activate the UPS self-test.
44..33 TTuurrnniinngg tthhee U UP PS S O Offff
1. Press and hold the UPS ON/OFF button until the beeper turns off. The UPS then transfers to the OFF
mode and the green power LED turns off.
If you are planning on removing the UPS or EBM (if applicable) from the DIN rail ensure all sources of AC power
have been disconnected and properly isolated.
44..44 B Baatttteerryy M Mooddee
When the UPS is operating on battery mode the yellow indicator will illuminate and the UPS will supply battery
power to the load.
44..55 U UP PS S A Allaarrm m IInnddiiccaattiioonn
The LED flashes when the battery needs to be recharged and tested. The LED will illuminate when the unit is
subjected to an overload condition. If the unit shuts down due to overload, the LED will flash and the alarm will
sound.
44..66 U US SB B C Coom mm muunniiccaattiioonnss
High-speed USB 2.0 Type-B peripheral communication port used to establish control and monitoring with
PowerAlert® Office software. PowerAlert Software is available as a FREE download at
tripplite.com/poweralert. .
44..77 R Reem moottee O ON N //O Offff TTeerrm miinnaallss
Allows the user to perform remote power on/off functions using a switch on terminals (non-polarized) to toggle
the unit to and on/off state.
NOTE Non-polarized terminals, no external voltage is required. Stranded UTP (Unshielded
Twisted Pair) wire for connections is recommended.