INSTALLATION & MAINTENANCE
MANUAL FOR REMOTE ALARM
PANELS
In order to familiarize yourself with the Remote
Alarm Panel, please read the instruction manual
thoroughly and carefully. Retain the manual for
future reference.
1.
Installation and Mounting of the
Controller
Carefully unpack the controller and inspect
thoroughly.
The controller is not free standing and must be
bolted securely to a wall. For dimensional and
weight data please refer to the respective data
sheets for the Remote Alarm Panels.
Figure #1 - Electric Remote Alarm Panel
Figure #2 - Diesel Remote Alarm Panel
2.
Electrical Connections
All electrical connections should meet national
and local electrical codes and standards.
The controller should be located or so protected
that they will not be damaged by water escaping
from pumps or pump connections. Current carrying
parts of controllers shall be a minimum of 12 inches
(305 mm) above the floor level.
?
Prior to starting, verify all data on the
nameplate such as, catalog number and AC line
voltage.
?
Inspect all electrical connections,
components and wiring for any visible damage and
correct as necessary. Ensure that all electrical
connections are tightened before energizing.
?
Install necessary conduit using proper
methods and tools.
?
Incoming Normal power and Supervisory
(backup) power connections are clearly marked L
and N and are located on the upper right side of the
microprocessor board.
O & M Manual IM05805008K
Remote Alarm Panels
EATON DFDAP-M / FDAP-M
1
EATON Corporation www.chfire.com
Effective: March 2011