Eaton’s Crouse-Hinds Business
IF 1756
1201 Wolf Street, Syracuse, New York 13208 • U.S.A.
Revision 1
Copyright
©
2015
New 05/15
All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy or
completeness thereof are not guaranteed. In accordance with Crouse-Hinds “Terms and Conditions of Sale,” and since conditions of use are outside our
control, the purchaser should determine the suitability of the product for his intended use and assumes all risk and liability whatsoever in connection therewith.
AIRCRAFT CABLE MOUNTING
1.
Mounting tabs are located 1” from each end of the luminaire from
the factory. If mounting tabs need to be relocated or become loose,
tighten the 10-24 screws to 21 in.-lbs. (see Figure 4) before hanging the
luminaire. Mounting tab retention bolts should be tightened to 65 in.-
lbs. in all four corners of the luminaire. Mounting tabs should be placed
equal distance from the ends of the luminaire to assure the luminaire
hangs level.
2.
Install two (2) aircraft cable assemblies to the luminaire with one
aircraft cable assembly at each end of the luminaire (refer to IF 1726 for
more information). Do not exceed an angle greater than 30° between
the cables and the gravity line. Adjust the length of the aircraft cable
assembly to assure the luminaire hangs level. Mount the luminaire a
minimum of 36 inches away from the ceiling. Refer to B-Line FIS-164
Instruction Sheet for further details and information.
3.
Use the factory installed wire (SOOW cable) for electrical connection to
the appropriate junction connection. See the wiring section in IF 1726
for more information.
JACK CHAIN MOUNTING
1.
Mounting tabs are located 1” from each end of the luminaire from
the factory (see Figure 4). If mounting tabs need to be relocated or
become loose, tighten the 10-24 screws to 21 in.-lbs. before hanging
the luminaire. Mounting tab retention bolts should be tightened to
65 in.-lbs. in all four corners of the luminaire. Mounting tabs should
be placed equal distance from the ends of the luminaire to assure the
luminaire hangs level.
2.
Chains should be cut to equal lengths to assure the luminaire hangs
level. Install four (4) hooks and four (4) chains to the luminaire. One
hook and one chain per mounting bracket found at each corner of the
luminaire. Mount the luminaire a minimum of 36 inches away from the
ceiling.
3.
Use the factory installed wire (SOOW cable) for electrical connection
to the appropriate junction connection. See the WIRING section in IF
1726 for more information.
Figure 2
Figure 3
Lock Screw
Lock Nut
Throat Bushing
Fixture Mounting
Tabs
Fixture Groove
10-24 Screws
Mounting Tab
Retention Screws
Figure 4
WARNING
Aircraft cable mounting is intended for dry locations only.
IHB Dust Cover Kit
IHB Lumen Confi guration
IHB8L DC2 KIT
8L
IHB16L DC2 KIT
16L
IHB24L DC2 KIT
24L
IHB32L DC2 KIT
32L
IHB48L DC2 KIT
48L
IHB64L DC2 KIT
64L
Pendant Mount
Bracket
(4) ¼-20
Screws, 2 Per
Side