Eaton BladeUPS Series, Инструкции по установке DOS

Страница: 11 / 32

Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3 5
l
Wire cutter for tie wraps
Note: You may find it useful to use a magnetized screwdriver when removing or replacing mounting screws.
Section 3 Moving the System and Battery Pallets
The BladeUPS cabinet is bolted to a wooden pallet and shrink-wrapped for traveling. If you are installing a new
transformer, it is also bolted to a separate wooden pallet. The batteries and the BladeUPS modules are packed
in two separate boxes with other accessory boxes within larger containers on a separate pallet.
WARNING
The forklift jacks must be inserted between the skids at the front of the pallet. If unloading instructions
are not closely followed, moving the pallets may cause serious injury.
To move the equipment and boxes on the pallets:
1. Verify that the forklift or pallet jack you will use is rated to handle the weight of the equipment or loaded
boxes and the pallet.
2. If not already moved, use a forklift or pallet jack to move the pallets to the installation area, or as close as
possible.
Note: Insert the forklift jacks between the skids at the front of the pallet.
Note: Do not park the pallet in a location that will interfere with installing the system.
Section 4 Unpacking
Note: Some set ups will be retrofitting their transformer configuration with a BladeUPS cabinet instead of
another type of Eaton UPS. If so, make sure the Eaton UPS bolted to the top of the transformer is
removed per your facility practice before unpacking the BladeUPS shipping cartons.
To unpack the equipment:
1. Remove the shrink wrap from the BladeUPS cabinet.
2. Cut the carton tie wraps with the wire cutters and open the two BladeUPS shipping cartons by lifting off
the top containment (see Figure 3).