Easy-Laser XT11, Руководство пользователя

Страница: 59 / 81

PREPARE
l
Check the sheaves for radial runout. Bent shafts will make it impossible to perform an accurate alignment.
l
Check the sheaves for axial runout. If possible, adjust with the mounting screws of the bushings.
l
Make sure that the sheaves are clean from grease and oil.
l
The distance from the belt to the axial face of the sheave can be different on the two sheaves. See "Sheave
width" on the next page
A. The Prepare icon is active in the workflow.
B. Tap to open machine properties. (Sheave width and tolerance.)
C. Tap input field to enter distance.
D. Tap to select detector.
E. The Display unit automatically recognize where the units are placed.
F. Set M-unit to the left or right.
Mount the units
The units are mounted on a flat machined surface with magnets. The magnets are very strong, try to soften the touch
by putting just one magnet to sheave first, then turning the other ones in. Non-magnetic sheave/pulleys can be aligned
as the units are very light and can be mounted using double-sided tape.
1. Mount the laser transmitter on the stationary machine.
2. Mount the detector on the movable machine.
3. Make sure all magnetic surfaces are in contact with the sheave.
OR
59
BELT