Easy-Laser XT11, Руководство пользователя

Страница: 50 / 81

Tolerance indicators
Values within tolerance are green. Values not within tolerance are red. The tolerance indicators are visible for a while.
To show them after they have disappeared, simply tap the vertical or horizontal value.
Indicates the tolerance level "good".
Indicates the tolerance level "excellent".
Indicates not within tolerance.
See "Tolerance" on page 37
Show Gap
By default, angular error/100 mm is displayed. To show gap, you need to set the coupling diameter. See "Coupling dia-
meter" on page 36
To show the result as gap, tap and .
Offset and angle values
The offset and angle value indicate how well the machine is aligned at the coupling. They appear in both horizontal
and vertical direction. These values are important to get within tolerance.
Offset:
The center lines of two axis are not concentric but parallel. This is measured at
the coupling centers. In this example, a negative offset is shown.
Angular misalignment:
The center lines of two axis are not parallel. In this example, a positive angle is
shown.
Offset and angular misalignment:
Misalignment is often a combination of both offset and angular misalignment.
Result table
In the Result view, tap to display the table view.
50
HORIZONTAL