5
REquIRED ITEMS
Before you begin using the Eastwood TIG200 DC, make sure you have the following:
• A properly grounded 110-120 VAC 50/60 Hz. 20 Amp Circuit or a 220-240 VAC 50/60 Hz. 30-50 Amp Circuit.
• NOTE: Unit must be grounded to work properly and safely!
• A clean, safe, well-lit, dry and well-ventilated work area.
• A non-flammable, long sleeve shirt or jacket (Eastwood #12762).
• Heavy-Duty Welding Gloves (#12590)
• An Auto Darkening Welding Mask to provide eye protection during welding operations.
Note: MUST be a #10 lens or darker.
• A compressed gas cylinder containing 100% Argon (must be used when TIG welding and is available
at any welding supply facility).
• Dedicated stainless steel wire welding brushes for each material to be welded.
• A dedicated fine grit synthetic stone grinding wheel or a Tungsten Sharpener.
uNPAcKING
Remove all items from the box. Compare with list below to make sure unit is complete.
• Eastwood TIG200 DC Welder with NEMA50-P Plug
• Shielding Gas Regulator
• Shielding Gas Hose
• Ground Cable with Clamp (10’)
• #17 TIG Torch (14’)
• Foot Pedal for Amperage Control
• 110-120 VAC to 220-240 VAC Adaptor Plug
• Instruction Manual
• Hand Held Shield
• Hammer/Brush
• #7 Cup (7/16”)
• #6 Cup (3/8”)
• #5 Cup (5/16”)
• Long Back Cap
• Short Back Cap
• 3/32” Collet Body
• 3/32” Collet
• 1/16” Collet
• 2.0mm Collet
• 2.0mm Red (Thoriated Tungsten)
