10
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
A Shielding Gas Bottle is
NOT INCLUDED
with your Eastwood MP140i but is neces-
sary to weld using Solid Wire. It can be bought at most local Welding Supply Stores.
Eastwood recommends the use of 75% Argon / 25% CO2 for shielding gas when
MIG welding Steel, 100% Argon for Aluminum, and Tri-Mix (90% He / 7.5% Ar / 2.5%
CO2) for Stainless Steel.
Carefully follow the following sequence to safely install and connect a Shielding
Gas Bottle:
• Place the Eastwood MP140i in its dedicated area or on a welding cart.
• Secure your Shielding Gas Bottle to a stationary object or mount to your
welding cart if it is equipped to hold one so that the cylinder cannot fall over.
• Remove the cap from the Shielding Gas Bottle.
• Install the Regulator Knob on the Shielding Gas Regulator
(FIG 10)
.
• Insert the large brass male fitting on the Shielding Gas Regulator into the
female fitting on the Shielding Gas Bottle
(FIG 11)
.
• Tighten the fitting with a wrench until snug, do not over tighten.
• Connect either end of the Gas Line included with your Eastwood MP140i to
the fitting on the regulator and wrench tighten until snug
(FIG 11)
.
• Connect the other end of the gas line to the fitting on the rear of the Eastwood
MP140i and wrench tighten until snug
(FIG 12)
.
• Check the gas line for leaks by slowly opening the valve on the gas bottle.
When welding the valve on the bottle should always be fully open.
FIG. 10
FIG. 11
FIG. 12
Do not use White Thread Sealing Tape on this connection as
it is an inert gas fitting and does not require it. If you have a
leak, check for burrs or dirt in the threads.
