Eastwood 20189 Скачать руководство пользователя страница 1

EXTRA LARGE VIEW

WELDING HELMET 

 INSTRUCTIONS

Item #20189 

© Copyright 2014 Easthill Group, Inc.     Instruction part #20189Q     Rev. 6/14

If you have any questions about the use of this product, please contact 

The Eastwood Technical Assistance Service Department: 800.544.5118  >>  email: [email protected]

PDF version of this manual is available online  >>  eastwood.com/20189manual

The Eastwood Company     263 Shoemaker Road, Pottstown, PA 19464, USA

US and Canada: 800.345.1178     Outside US: 610.718.8335     Fax: 610.323.6268     eastwood.com

TROUBLESHOOTING

•  Auto-Dimming does not function, (will not darken):

-   Dirt may be blocking sensors located at upper, outer corners of the lens assembly 
 

Clean lens assembly

-  Batteries may be low 

Expose the solar cells to light source to recharge

-  Dirt may be blocking solar cells at top of lens assembly 

Clean lens assembly

•  Slow response for darkening:

-   Operating temperature too low 

Do not use below 23°F (-5°C)

•  Poor vision through lens:

-  Dirt or excessive pitting may be blocking view 
 

Clean lens assembly

•  Helmet slips during use:

-  Helmet fi t not adjusted properly 
 

Follow fi t adjustment steps in instructions

ADJUST FIT:

To adjust the fi t of the helmet:
 • 

Headband

 – Push Knob in and Turn Clockwise for decreasing size (tighten) or rotate 

    Counter-Clockwise to increase size (loosen). 
 • 

Width/Height

 – Push in small button on the overhead band, slide band in to shorten band or pull  

    out to lengthen band. Snap button into the nearest of 5 available holes.
 • 

Flip-up Retention

 – This will allow the helmet to stay in the “fl ipped-up” position. Tighten or  

    loosen knobs on either side of the helmet to increase or decrease friction. 

MAINTENANCE:

•  Clean outside and inside of lens with a soft cloth and small amount of glass cleaner. 

Note:

 Do not use excessive glass cleaner or allow the lens assembly to become wet or the  

    sensitive electronics will be destroyed. Never use solvents.
  •  Clean headband with a cloth dampened with mild soap and water. Allow to dry thoroughly.
  •  Check lens assembly for damage before each use. If cracked or broken, DO NOT USE.

Отзывы: