Eastsign
11
R
O
TAR
Y
HE
AT
PRE
SS
SO
T-
64H
USER
MANU
AL
6. Operation Guide
6.1.
Before switching on the machine, make sure that all electrical wires are connected correctly. The body of
the machine must be connected to ground. Press the power switch and belt start rotary switch. Then,
adjust the rotary speed on speed adjustor (6) to optimum value. When the heating roller start revolving,
press “heating” button (5) and adjust the temperature to optimum value. (Default temperature is 220
℃
)
6.2.
When the machine reaches the preset temperature, let the thermostat stabilize the temperature for a
while. Check the transfer result with small piece of printed transfer paper and substrate. Adjust the
temperature with reference to the testing result of the transfer.
6.3.
Place the printed transfer paper and tissue paper (to prevent the contamination of blanket) in proper
position on working table and main machine. Feed the tissue paper first and collected by the shaft at the
rear. then feed textiles flatly. Lastly, feed the printed transfer paper to the machine evenly.
6.4.
When fabric and transfer paper comes out, attach the fabric to collecting rollers at the rear of the
machine or just drop on (19) Cloth pocket. Then, attach the transfer paper to collecting roller at the front
side of the machine under the table. So all materials can be collected automatically. The speed of
collecting transfer paper can be adjusted by the controller (8).
6.5.
During the working process, the transfer speed can be adjusted (by “6”) according to the vividness of the
print.
6.6.
When the transfer is finished, switch off the heating button to let the machine cooling down. The
operators have to monitor the machine until the temperature drops to less than 80
℃
. Then, the
operators may switch off the machine.).
6.7.
When there is sudden blackout and the machine is working at high temperature, using soft paper board
or paper to separate the felt from hot oil drum. it prevents permanent damage to felt.
