EASTMAN BLUE JAY-5H, Инструкция по эксплуатации и иллюстрированный список запасных частей

Страница: 7 / 52

7
Form CR-50-0433
Air Regulator Valve
The main air regulator valve, when adjusted properly at 50-
70 PSI, will produce a quiet, smooth lifting and clamping
motion. To Adjust pressure, Locate the main regulator valve
on the main lift module. Pull the "Adjust" knob up and turn
clockwise to increase pressure and counterclockwise to
decrease pressure. After adjustment is made, push knob
down to lock in place.
CAUTION
Improper adjustment can cause personal injury or
damage to your machine. Adjustment should be made
by qualified personnel.
Maintenance
Note:
All maintenance procedures may be performed with
knife motor (Blue Jay) installed on track.
Knife Motor
Warning
This machine is equipped with sharp knife. Keep hands
away from knife area at all times. DO NOT handle cutting
machine at any time unless terminal block is disconnected
from power supply. Knife guard should be raised only
enough to clear the material being cut. When machine is not
in use, knife guard should be set at its lowest position. DO
NOT OPERATE THIS MACHINE WITH SAFETY
GUARDS REMOVED.
Air Line Lubricator
The Blue Jay has an in-line lubricator designed to lubricate
the air cylinders and valves. Check oil sight tube bowl daily
for proper level of lubricant. To fill sight tube bowl disconnect
air source or turn air pressure valve off and relieve pressure.
Remove sight tube bowl by turning 1/4 of a turn counter-
clockwise. Fill sight tube bowl 3/4 full with genuine EAST-
MAN air line lubricant (242C1-4 pint size). Replace sight
tube bowl and air source.
Knife Replacement
Loosen thumb screws "E" and remove Knife Side Guard as
shown. Turn the knife so the knife hole lines up with hole "F"
in standard. Insert knife removal pin (17C11) into hole "F".
Remove the Lock Nut that retains the blade with special
spanner wrench (95C1-12). When installing a new knife, be
sure the name Eastman Machine Company is facing
outward and knife seats on the knife gear. Install knife
locknut and secure with spanner wrench. Secure knife
guard in operating position. Refer to page 32 for replace-
ment knives.
CAUTION: Discard used sharp knives with care.
Emery Wheel Adjustment
As the Emery Wheels wear away and become farther apart,
they must be adjusted. Emery Wheels must be adjusted from both
sides to ensure proper centering of wheels over the knife.
LOCKNUT
KNIFE
SIDE
GUARD
5" KNIFE
E
F