22 Operation
E-Stop or Emergency Stop
A red E-Stop button is placed centrally above the heat tunnel control
panel. In the event of an emergency, press the E-Stop button in. This
brings the heat tunnel to a halt in a way to avoid damage or
excessive film waste.
CAUTION!
When the Heat Tunnel unit is stopped or turned off
it will require some time to cool to ambient room temperature.
Be aware of heat inside of the tunnel and hot surfaces, belts,
or rollers.
When the E-Stop is pressed, the heat tunnel conveyor motor and heaters are turned off,
but blower motors are allowed to continue to blow to allow the tunnel to cool down in a
way to prevent damaging heat concentrations. Depending on heat settings, the time
required for the system to cool down completely may vary.
To return the machine back to normal operation once the E-Stop has been pressed,
verify the emergency condition has been cleared, then press and turn the E-Stop button
a quarter-turn so it pops out to normal operating position.
Sealer Operation
Seal Power Off / On
Turn on the power to the seal heads by turning the switch below the
front seal head to the On position. The two seal bars that form the L-seal
are at right angles to each other. The front seal which runs parallel to
the long axis of the machine is sometimes referred to as the M.D. for
Machine Direction seal, and the side seal which runs from the front to
the back of the machine and perpendicular to the long axis is sometimes
referred to as the T.D. for Transverse Direction seal.
M.D. Thermo. — Machine Direction or Front Seal Temperature Control
Set the temperature for the front hot knife seal using the
“M.D. Thermo” temperature controller. This temperature
controller operates similar to the heat tunnel temperature
controller.
•
Press the first button to begin setting the temperature.
•
Press the < button to select the digit to change. The
selected digit will blink.
•
Press the Up or Down direction arrows to increase or
decrease the value of the selected digit.
Emergency Stop
E-STOP
OFF
SEALER
ON
Содержание Value VS1620TK
