Operation 21
Setting the Tunnel Temperature
Use the programmable switch to set the temperature
inside the heat-shrink tunnel. The programmable switch
will display the current temperature inside the tunnel
(top) and the temperature setting below.
Press the SET button to set the temperature.
Press this button to select the digit to change.
The selected digit will begin to flash.
Press the Up or Down arrows to change
the value of the selected digit.
Press the “SET” button to save the new values.
Attention!
Do Not
set the temperature higher than 350°F. Setting the
temperature higher than 350°F will damage the machine and the
product.
The output light will turn on while the tunnel is heating up.
Blower Speed
Use the Blower SPEED dial to set the air flow inside the shrink tunnel.
The blower speed will vary according to the product dimensions and film
properties.
Conveyor Speed
Use the Conveyor SPEED dial to set the conveyor speed through the
shrink tunnel. The conveyor speed will vary according to the product
dimensions and film properties.
Содержание Value VS1620TK
