Eastey SB-2 EX-Auto, Руководство пользователя

Страница: 14 / 59

14 Installation
Location Requirements
Move the case taper to the desired location. To lift or move the case taper without
casters installed, you will need to use a pallet jack or forklift to lift and move it. If you
have installed the casters, release the brake lever on each of the locking casters to
move the taper easily over a smooth flat surface. Re-engage caster brake levers when
the case taper has been moved to its location.
When installing the carton sealer please be aware of the following considerations:
1. The mounting surface is flat and level.
2. Conveyor or packing table height.
3. Alignment with packaging line.
When the case taper is positioned in the operating location you will need access to:
1. The Main Power Switch and Control Panel, with Start/Run and Stop buttons and
E-Stop.
2. Height and width adjustments.
3. Both upper and lower tape cartridges for tape loading.
4. Air in and supply hose connection.
A packing table may be provided at the infeed end where the packer can fill boxes and
position the flaps while feeding the boxes into the machine for closing and sealing. It is
also convenient to have a pack table at the exit end of the taper.
It is essential that the table and conveyor be at the machine bed height.
The machine should be placed on a flat, level floor so that it does not rock or move.
When placed for operation, securely lock the locking casters. We recommend that the
machine be securely locked in place when in operation.
Connect the air supply hose to the filter/regulator assembly on the side of the machine.