Eastey Perfomance EN Series, Руководство пользователя

Страница: 23 / 40

Maintenance 23
Replacing the Takeaway Conveyor Motor
NOTE: This procedure requires an Allen or hex wrench, and a 7/16-inch
box-end wrench.
1. Disconnect the L-sealer power plug from the electrical power source.
2. Disconnect wires # 14 and # 16 from inside the panel and pull them out. Note the
color of wires and where they are connected.
NOTE: Wiring color connections to the conveyor motor.
•
Red and yellow are together and capped.
•
Brown, purple, and orange are together and capped.
•
Black is connected to black for power.
•
White is connected to white for power.
•
Green is connected to green to ground or motor ground.
3. Loosen the ¼-20 drive roller adjustment bolts and remove the timing belt.
Remove the timing pulley from the motor (requires an Allen or hex wrench).
4. Remove the three ¼-20 bolts. These hold the motor in place. As the last bolt is
removed, hold onto the motor so it does not fall. (Bolt removal requires
7
/
16
-inch
box end wrench.)
5. Place the new conveyor motor in place of the conveyor motor removed, and
install the ¼-20 bolts.
6. Re-install the timing pulley. Make sure it is not rubbing against the conveyor
frame, and then tighten both set screws.
7. Reinstall the timing belt. Tighten the ¼-20 drive roller adjustment bolts.
Reconnect the power wires #14 and # 16. Refer to the wiring color connections
note on the preceding page to complete motor wiring connections.
8. Refer to the instructions for Wire Belt Repair Splicing.
Caution! Disconnect main power to the conveyor before attempting to
repair or adjust belt.
Wire Belt Repair Splicing
Caution! Disconnect main power to the conveyor before attempting to
repair or adjust belt.