Eastey Perfomance EN Series, Руководство пользователя

Страница: 22 / 40

22 Maintenance
Changing Hot Knife Inserts and Cutting Rules
1. Disconnect the L-sealer power plug from the electrical power source.
CAUTION! Always be aware of the cutting edges while replacing the
knife edges. Handle the knife blades carefully.
2. Remove the #10-32 screws holding the inner side film clamp and remove the
#10-32 screws holding the outer front film clamp.
NOTE: One #10-32 screw is behind the aluminum arm casting. This does
not need to be removed. Push the product tray in all the way.
Swing the film clamp down and to the right over the product tray,
then pull it out and rest the film clamp on the product tray.
3. Remove the #8-32 flat head screw on both side-seal and front-seal bars.
4. Remove the insert and cutting rule, both at the same time.
5. Place the replacement cutting rules into the new inserts, both at the same time,
ensuring that the beveled edge is in the corner.
6. Push the beveled edges together.
NOTE: The inside beveled edges of the cutting rule need to come
together. The outsides do not. Be sure the cutting rules are
touching.
7. Install the #8-32 flat head screws, but do not tighten them at this point.
8. Heat the seal bar up to the set point.
9. Adjust insert and cutting rule if they separate at the corner.
10. Tighten the #8-32 flat head screws while the seal bars are hot.
11. Turn off heat and allow the sealer to cool down, and then reinstall film clamps.
Takeaway Conveyor Maintenance and Replacement
From time to time it will be necessary to disassemble the conveyor when it requires an
adjustment for a different product size or if worn parts need to be replaced or for general
maintenance. Instructions provided in this user guide are very general. If these
generalized instructions do not address your specific conveyor issue, contact a certified
representative of Eastey or contact Eastey Enterprises directly (Eastey.com/contact-us).