6
When the communicator is set to connect the internal resistance, no external
connection resistance is required.The connection mode is shown below.Connection
leads are non-polar.
Figure 7-3 Connection Guidance with no external resistance
5.2 Turn on and Turn off HART 475
First, check if the battery of communicator has been equiped well. After the
meter loop is connected correctly, hold down the power button for three seconds
and the LCD screen is lit to indicate that the device has been working.
Hold down the power button for three seconds in the startup state, and press the
confirm button after the prompt appears. The shutdown is complete and the screen
is closed.
六.
Function Introduction
Once connected to the device, you will be taken to the menu type selection
interface, which has three options:
1 Pressure Menu
2Temperature Trans
3Universal MeNU
HART METER