18
5 Simulation of temperature
sensor
5.1 Simulating Thermocouples
Connect calibrator input/output terminal to the instrument to be tested using
thermocouple. The connecting diagram is shown below, Proceed as follows to simulate
a thermocouple:
1.
Connect thermocouple to the TC input/output plughole of calibrator as shown in
Figure 5.1-1.
2.
If necessary, press
to select output mode.
3.
Press
to select thermocouple function. If necessary, continue pressing the
key to select thermocouple graduation.
4.
Press
or
to select temperature. Press
or
to select digit.
Figure 5.1-1
5.
Press
to display the DC mV value, which continue to display for 3s and