2.3 Load setup operation
Through the system menu, you can enter the load setup interface, as shown in Figure 2.3. Un
der this interface, we can complete the relevant settings about the range, limit value and delay turn
off of the load.
Operation description
:
1.Select the operation item by rotating the knob. 2.Non numeric
parameters switch settings according to[Enter]key. 3.Digital parameters, press the[Enter]key to
enter editing mode, select the appropriate number of digits by the direction key, then rotate the
knob to adjust the value,[Enter]key to confirm the input. 4.Return to the next level by[Esc].
Fig. 2.3 load setup interface diagram
2.4 Basic mode operation
Electronic load can work in the following basic measurement modes: constant current mode
(CC), constant voltage mode (CV), constant resistance mode (CR), constant power mode (CP), co
nstant current and constant voltage mode (CC + CV), constant resistance and constant voltage mo
de (CC + CR). The above six mode parameters can be set at the measurement interface. Among th
em, the arbitrary mode main interface can enter the mode selection interface according to the [Mo
de] key, as shown in Figure 2.4.
Operation description
:
1.Select the operation item by rotating the knob. 2. press [Enter] k
ey to confirm the selected mode. 3. press the [Esc] button to return to the next level interface.
6