22
6 Simulation of temperature
sensor
6.1 Simulating Thermocouples
Connect calibrator input/output terminal to the instrument to be tested using the
thermocouple. The connecting diagram is shown in Figure 6.1-1. Proceed as follows to
simulate a thermocouple:
1.
Connect the thermocouple to the TC input/output plughole of the calibrator.
2.
If necessary, press
to select
mode.
3.
Press
for the TC display. If desired, continue pressing this key to select
the desired thermocouple type.
4.
Enter the temperature you want by pressing
and
keys. Press
or
keys to select a different digit to edit.
Figure 6.1-1
5.
Press
to display the DC mV value. The DC mV value continue to display
for 3s and then automatically return to the original display.
