Fault code list
open: (1)
Under the condition of shutdown, At the same time, hold down the three keys pointed to by the
arrow, and you will hear a beep of the hand controller in a few seconds.
(2)
Select one of the two project patterns shown in the following figure as needed
Status
,indications
Fault
numbe
Fault description
Possible cause
Exclusion method
remarks
1
The hand controller button
was pressed for more than
45s without letting go
Button stuck
1.
Check the status of each button
carefully
2.
Replace the hand controlle
2
The hand controller does not
communicate with the center
board for more than 4s
Bad contact or fracture
of inserting wire
1. Check or replace the plug-in
cable
2. Replace the hand controlle
3. Replace the center board
3
The movement plate does
not communicate with the
center board for more than
4s
Bad contact or fracture
of inserting wire
1.
Check or replace the plug-in
cable
2.
Replacement of movement
board
3.
Replace the center board
40
The position sensor is
abnormal of the Movement
walking moto
1.
The position sensor
is broken
1.
Replacement of sensors
2.
Check the connection
3.
Replacement of movement
board
(1)
Detection when
function is turned on
(2)
Shut down
automatically in the
event of failure time.
And not allowed to boot.
41
Position coding anomaly of
the Movement walking moto,
That is ,the code disk is in the
incorrect position.
1.
The position sensor
is broken
2.
Movement
overshoot
1.
Replacement of sensors
2.
Move the movement to the
initial height position
3.
Replacement of movement
board
(1)
real-time detection
(2)
Shut down
automatically in the
event of failure time.
And not allowed to boot.
3
