PLEASE:
CALL US IF YOU HAVE DIFFICULTY BEFORE YOU
RETURN THIS TO THE STORE.
PARTS HOT LINE PHONE: 574-848-7491
ASSEMBLY and OPERATING INSTRUCTIONS
EarthWay
Ev-N-Spred
®
M24
SSD
Series
Broadcast Spreader
HELPFUL HINTS:
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use.
Fertilizer stuck on the impeller blades will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean your spreader thoroughly after each use.
Wash between the shut off plate and bottom of the hopper.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
1.
Remove and identify loose parts from carton.
PAGE 1
2.
Position hopper on side. Install frame using (4) 1/4-20
x 1-1/2” Pan Head Philips machine screws and (4) 1/4-20
nylon insert locknuts. First put bolts through holes in
frame then through holes in bottom of hopper. Secure
with locknuts. Tighten these locknuts now.
