EARTHSTONE OVENS PRE-ASSEMBLED GAS OVEN INSTALLATION INSTRUCTIONS
16
GAS FIRE START-UP PROCEDURES
MAKE SURE ALL POWER PLUGS ARE CONNECTED.
GAS PRESSURE, BEFORE OVEN VALVE, SHOULD BE 7” W.C. FOR NATURAL GAS
AND 10” W.C. FOR LP GAS. GAS FIRE MANIFOLD PRESSURE IS SET AT THE
FACTORY. PLEASE SEE CHART ON THE BOTTOM OF PAGE 2.
ADEQUATE CLEARANCE MUST BE PROVIDED FOR AIR OPENINGS INTO THE
COMBUSTION CHAMBER, FOR SERVICING AND PROPER OPERATION (PAG AND
PAGW MODELS ONLY).
A MIIMUM OPEIG OF 24” X 24” MUST BE LOCATED
O THE BOTTOM HALF OF THE OVE. THIS AREA CAOT BE BLOCKED
CHECK TO SEE THAT MAIN GAS VALVE ON GAS BURNER CONTROLLER BOX IS
ON.
SET TEMPERATURE CONTROLLER TO BELOW 200 DEGREES BY HOLDING DOWN
RED BUTTON AND TURNING BLACK KNOB COUNTER CLOCKWISE TO DECREASE
AND CLOCKWISE TO INCREASE.
REMOVE OVE DOOR. THE DOOR SHOULD OT BE CLOSED WHE OVE IS
FIRED. WITH A 2 SIDED OVE YOU CA HAVE OE DOOR CLOSED.
MOVE HI/LO – HI/OFF SWITCH TO “HI/LO”. (UPWARD CLICK)
TURN ON/OFF SWITCH TO “ON”. INITIALLY OVEN MAY NEED TO BE TURNED ON
AND OFF 4 OR 5 TIMES (IN 1 SECOND INTERVALS) IN ORDER TO BLEED THE GAS
PIPE.
CLICK “ON” WAIT 1 SEC, TURN OFF.
CLICK “ON” WAIT 1 SEC, TURN OFF.
LONGER PIPE LENGTHS MAY REQUIRE MORE BLEEDING.
ALLOW OVE TO FIRE FOR AT LEAST 5 HOURS AT LOW FLAME FOR 2 DAYS
AFTER 2 DAY FIRIG ADJUST TEMPERATURE TO ORMAL OPERATIG RAGE 600F-750F
Oven curing is a process of removing moisture from the oven that has accumulated during
the oven installation. If you still see moisture from the oven you may need to cure the oven
for a few more days. Improper curing may cause small pieces of the oven to pop. Although
this is not harmful to the oven in anyway, please follow these procedures.
