EARTHSTONE OVENS PRE-ASSEMBLED GAS OVEN INSTALLATION INSTRUCTIONS – ETL LISTED
16
GAS FIRE START-UP PROCEDURES
MAKE SURE ALL POWER PLUGS ARE CONNECTED.
GAS PRESSURE, BEFORE OVEN VALVE, SHOULD BE 7” W.C. FOR NATURAL GAS
AND 12” W.C. FOR LP GAS. GAS FIRE MANIFOLD PRESSURE IS SET AT THE
FACTORY. PLEASE SEE CHART ON THE BOTTOM OF PAGE 2.
ADEQUATE CLEARANCE MUST BE PROVIDED FOR AIR OPENINGS INTO THE
COMBUSTION CHAMBER, FOR SERVICING AND PROPER OPERATION (PAG AND
PAGW MODELS ONLY).
A MINIMUM OPENING OF 24” X 24” MUST BE LOCATED
ON THE BOTTOM HALF OF THE OVEN. THIS AREA CANNOT BE BLOCKED
CHECK TO SEE THAT MAIN GAS VALVE ON GAS BURNER CONTROLLER BOX IS
ON.
SET TEMPERATURE CONTROLLER TO BELOW 200 DEGREES BY HOLDING DOWN
RED BUTTON AND TURNING BLACK KNOB COUNTER CLOCKWISE TO DECREASE
AND CLOCKWISE TO INCREASE.
REMOVE OVEN DOOR. OVEN DOOR SHOULD NOT BE CLOSED WHEN OVEN IS
FIRED. OVEN DOOR CAN BE POSITIONED AT A 45 DEGREE ANGLE TO ALLOW
FOR MORE RAPID HEAT UP. WITH A 2 SIDED OVEN YOU CAN HAVE ONE DOOR
CLOSED.
MOVE HI/LO – HI/OFF SWITCH TO “HI/LO”. (UPWARD CLICK)
TURN ON/OFF SWITCH TO “ON”. INITIALLY OVEN MAY NEED TO BE TURNED ON
AND OFF 4 OR 5 TIMES (IN 1 SECOND INTERVALS) IN ORDER TO BLEED THE GAS
PIPE.
CLICK “ON” WAIT 1 SEC, TURN OFF.
CLICK “ON” WAIT 1 SEC, TURN OFF.
LONGER PIPE LENGTHS MAY REQUIRE MORE BLEEDING.
ALLOW OVEN TO FIRE FOR AT LEAST 5 HOURS AT LOW FLAME FOR 2 DAYS
AFTER 2 DAY FIRING ADJUST TEMPERATURE TO NORMAL OPERATING RANGE 650F-750F
Oven curing is a process of removing moisture from the oven that has accumulated during
the oven installation. If you still see moisture from the oven you may need to cure the oven
for a few more days. Improper curing may cause small pieces of the oven to pop. Although
this is not harmful to the oven in anyway, please follow these procedures.
