www.eagletone.com
eagletone.com
INSTALLATION
Hang the EAGLETONE PARLED 36 on a frame and adjust it at
the desired angle.
If the DMX 512 protocol is to be used to control the light,
connect the signal wire. Plug one end of the signal wire into
the INPUT socket on the rear of the projector system. Plug
the other end into the OUTPUT socket of the DMX controller.
Pins of the signal input socket correspond to: 1 = Ground, 2 =
data-, 3 = data+.
XLR male socket
XLR female socket
1. Ground
2. Cold
3. Hot
1. Ground
DIPSWITCH SETTINGS IN STAND-ALONE MODE
DIP No. ON
DIP 1 Red
DIP 2 Green
DIP 3 Blue
DIP 4 —
DIP 5 Strobe effect, RGB full on, adjustable speed with DIP
1/2/3/4
DIP 6 Color change, adjustable speed with DIP 1/2/3/4
DIP 7 Color fade, adjustable speed with DIP 1/2/3/4 DIP
1/2/3/4
DIP 10 DMX addressing enabled
METHOD FOR DIALING ADDRESSES IN DMX MODE
(for a 16 channel light DMX 512 controller)
Dip-Switch
1
2
3
4
5
6
7
8
9
Value
1
2
4
8
16 32 64 128 256
SYNCHRONIZING SEVERAL PARLED 36 LIGHTS
Choose a light that will operate as “Master”.
Connect its DMX OUT to the next light’s DMX IN with a DMX
cable (caution: a microphone cable does not have the same
impedance nor the same bandwidth, it will therefore generate
errors).
Repeat this procedure until all lights are linked.
Lower the Dip switch No.10 on all the “slave” lights and
select the desired functions as explained above. The lights
connected together will then execute the same operations.
CHANNEL
DMX FUNCTION
Channel 1
Dimmer/strobe
Channel 2
Red
Channel 3
Green
Channel 4
Blue
CONTENTS
1 × LED unit
1 × instruction manual
user’s manual
