The device is comprised of two sub-assemblies: a male bullet catch and a female
receiver with a locking plate.
1. Align the units so that the bullet catch and receivers line up.
2. Pull the lever and push the two units together so that the bullet catch
is pushed all the way into the receiver.
3. Release the lever and the two units are now securely docked together.
4. To release the two units, pull the lever and slowly pull the two units
apart. Release the lever and now your units are separate.
DOCKING DEVICE
OPERATIONS MANUAL & INSTRUCTIONS
Director’s Choice
®
Cold Food Unit with
Refrigerated Base
Models #DCS4-CFRB & DCS5-CFRB
EG10077 Revised 12/07
PART #366615
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group. ©2007 by the Eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
Retain this manual
for future reference.
bullet catch
receiver
lever
CAUTION
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING
CARRIER FOR ANY DAMAGE.
SAVE YOUR BOX AND ALL PACKING MATERIALS.
YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED
IMPROPERLY PACKED.
OPERATION FOR MECHANICAL COLD PANS
All units come equipped with 110V, 60 cycle, single phase refrigeration units. The unit is ready to operate as soon as it is plugged in.
However, we do recommend that the unit be plugged in and allowed to cool for approximately 30 minutes before using. The unit has
been pretested and set for proper operation. The thermostat has been set from 35˚ to 40˚F.
1. Connect unit to proper power source (120V AC, 60Hz, 15A, single-phase).
2. Turn unit on.
3. With ambient room temperature of 75˚F, allow 60 - 90 minutes before loading with food. This allows interior to cool down to the
correct storage temperature. The thermostat is preset at the factory to maintain an average interior temperature of 38˚F.
MAINTENANCE FOR MECHANICAL COLD PANS
Proper cleaning of the unit is is required. When rubbing or scouring, always move gently in the direction of the polish lines (grains).
A Scotch-Brite™ general purpose pad may be used. DO NOT USE STEEL WOOL. Clean condenser coil regularly. Defrost unit whenever
1/2˝ of ice forms on inner liner. Keep well ventilated.
MAINTENANCE FOR LAMINATES
Laminate surfaces should be cleaned with warm water and mild soaps. Non-abrasive cleaners may also be used. Cleaning products
containing bleaching agents should not be used, large quantities of these agents or extended periods of time can cause discoloration.
CAUTION:
1. This equipment is designed and sold for commercial use only by personnel trained and experienced in its operation and is not sold
for consumer use in and around the home nor for use directly by the general public in food service locations.
2. Do not immerse unit in water.
3. All repairs should be done by an authorized service center.
4. Unit should be turned off when not in use. It is recommended that unit be disconnected from power supply by removing plug from
receptacle or shutting off power disconnect supply to the unit.
