ASSEMBLY INSTRUCTIONS
Poly/Richlite
®
Drop Shelf
PART #374830
Eagle Foodservice Equipment, Eagle MHC, SpecFAB
®
, and Retail Display are divisions of Eagle Group. ©2010 by the Eagle Group
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
EG9865
Revised 05/10
CAUTION
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER FOR ANY DAMAGE.
SAVE YOUR BOX AND ALL PACKING MATERIALS.
YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED IMPROPERLY PACKED.
Please note:
Locations of drop brackets to be determined by installer. Hardware for attaching drop brackets to wall not included.
* IMPORTANT
: Wall mounted units must be attached to a properly constructed and sound wall. For walls constructed of wood or steel
studs, the mounting points must be directly on the stud or suitable in-wall-grounds of plywood or sheet metal. Eagle Group cannot
be held responsible for the failure of the device or any other devices due to improper installation.
(continued on page 2)
bracket
(folded
down)
countersink
screws (not
included)
wall
predrilled
holes
Step 2 - Predrill holes into wall.
Predrill pilot holes into wall where holes are marked.
Step 3 - Attach drop
brackets to wall.
Attach to wall using
countersink screws
(not included).
Step 1 - Mark drop bracket holes onto wall.
• Determine location of drop brackets
*
.
• Draw centerlines
**
.
• Using one of the drop brackets as a guide
**
, mark hole
locations onto wall.
**
Using a level is strongly suggested to make sure the centerlines are
vertically and horizontally level and parallel.
centerlines
holes
marked
holes
marked
bracket used as
guide for marking
locations of holes
(FRONT VIEW)
