EA Technology CableData CDC2, Руководство по эксплуатации, Страница: 36 / 59

EA Technology CableData Collector Operating Manual 1365/L/01/1
Page 32 of 54
Figure 39 shows an example of a correctly entered voltage option. With the new value
entered, click
Add .
Figure 39 - Correct voltage entry
10.4.8 Switch Position
The
Switch Position option is to enter the status of any switch that may be present on the
cable at the point of measurement. If there is no switch present, then Absent should be
selected. The Open option would be for cases when the switch is open, and the cable is
energised but with no load. The Closed option is for when the switch is closed and the cable
is energised and carrying a load. It is only possible to perform testing on energised cables.
The options are shown in Figure 41Figure 40.
Figure 40 - Switch position selection
10.4.9 Commencing Data Capture
With all of the required fields filled in, it is now possible to start the data capture. Press the
start button shown in Figure 41 to start the capture process. Once data capture is started, all
of the data entry fields will be locked and it will not be possible to modify any of the fields
until the capture is complete.
Figure 41 - Start button
10.4.10 Aborting Data Capture
If the data capture process is taking a very long time, or needs to be halted for any other
reason it is possible to cancel the data capture at any time. Some stages of the data capture
may be skipped to allow progression to later stages of the capture progress.
It is recommended that if, after 5 minutes on a waveform capture stage, the bar is not
showing any signs of moving then the data capture should be skipped to the next stage