E2S D1xL1FV725-A, Инструкция по эксплуатации, Страница: 1 / 20

INSTRUCTION MANUAL
D1xL1 & D1xL2
Loudspeaker
Class I, Zone 1, 2, 21 & 22
European Safety Systems Ltd. Impress House, Mansell Road, Acton, London W3 7QH www.e2s.com Tel: +44 (0)208 743 8880
Document No. D190-00-201-IS Issue 3 21-12-2023 Sheet 1 of 6
D1xL1F D1xL2F D1xL2H
1)
Product Table
Unit Type Code Input Power (Watts) Max I/P Volts
Sound Pressure Level dB(A)
Max Rated Pink Noise @ 1W
D1xL1FV100-A 100V Line 15 100
117 101
D1xL1FV070-A 70V Line 15 70
D1xL1FR008-A 8 Ohm 15 10.95
D1xL1FR016-A 16 Ohm 15 15.49
D1xL1FV725-A
25V 15 25V
70V 15 70.7V
D1xL2FV100-A 100V Line 25 100
123 104
D1xL2FV070-A 70V Line 25 70
D1xL2FR008-A 8 Ohm 25 14.14
D1xL2FR016-A 16 Ohm 25 20
D1xL2FV725-A
25V 25 25V
70V 25 70.7V
D1xL2HV100-A 100V Line 25 100
126 106
D1xL2HV070-A 70V Line 25 70
D1xL2HR008-A 8 Ohm 25 14.14
D1xL2HR016-A 16 Ohm 25 20
D1xL2HV725-A
25V 25 25V
70V 25 70.7V
Frequency Range: 400Hz to 8000Hz
The table shows the input current taken by the various Loudspeakers.
Nominal current at nominal voltage.
Table 1: Electrical Ratings.
2)
Warnings
CAUTION
TO
REDUCE THE RISK OF IGNITION OF HAZARDOUS
ATMOSPHERES:
DISCONNECT FROM SUPPLY BEFORE OPENING.
KEEP TIGHTLY CLOSED WHEN IN OPERATION.
WARNING
FIT SEALING FITTING IN CONDUIT RUNS WITHIN 18 INCHES FROM
ENCLOSURE.
EQUIPMENT MUST NOT BE INSTALLED WITH THE HORN FACING
UPWARDS OF HORIZONTAL
DO NOT OPEN WHEN AN EXPLOSIVE ATMOSPHERE IS PRESENT
DO NOT OPEN WHEN ENERGISED
POTENTIAL ELECTROSTATIC CHARGING HAZARD - CLEAN ONLY
WITH A DAMP CLOTH
ENCLOSURE ENTRIES: TWIN M20 X 1.5 / SINGLE 1/2” NPT
ATEX/IECEx & UKEx INSTALLATIONS: IF TEMPERATURE EXCEEDS
70°C AT ENTRY OR 80°C AT BRANCHING POINT USE SUITABLE
RATED CABLE AND GLANDS
ATTENTION
POUR REDUIRE LE RISQUE D’INFLAMMATION DES ATMOSPHÈRES
DANGEREUSES :
COUPER L 'ALIMENTATION AVANT OUVERTURE.
CONSERVER FERMÉ PENDANT LE FONCIONNEMENT.
AVERTISSEMENT
CONDUITS DOIVENT ETRE SCELLES EN MOINS DE 18 POUCES.
ÉQUIPEMENT NE DOIT PAS ETRE INSTALLE AVEC LE KLAXON
TOURNEE VERS LE HAUT DE HORIZONTAL.
NE PAS OUVRIR UN PRESENCE D’ATMOSPHERE EXPLOSIVE
NE PAS OUVRIR ENERGIE
DANGER POTENTIEL CHARGE ÉLECTROSTATIQUE - NETTOYER
UNIQUEMENT AVEC UN CHIFFON HUMIDE
ENTRÉES DE BOÎTIER: 2 x M20 X 1.5 / 1 x 1/2” NPT
ATEX/IECEx & UKEx INSTALLATIONS : SI LA TEMPÉRATURE
DÉPASSE 70 °C À L'ENTRÉE OU 80 °C AU POINT DE
BRANCHEMENT,
UTILISER UN CÂBLE ET DES JOINTS
D'ÉTANCHÉITÉ APPROPRIÉS