QSG-EVLT-00449_R00_XXXX00_01_EN_2022-11-02
3/17
Safety advisory / Warranty
GOOD PRACTICES AND SAFETY INSTRUCTIONS
Safety recommendations
The device is supplied with 100 / 240 V AC, it is mandatory to connect it to the ground with a
good link to the ground, to protect against electric hazard or electrocution.
Recommendations for the test environment
Keep the test area as clean as possible.
Recommendations for operators
E-XTEQ recommends that the operators who use the devices have training and a level of
qualification that correspond to the job to perform.
General recommendations
— Read the user manual before using the device.
— All electrical connections to the device must be equipped with safety systems (fuses, circuit
breakers, etc.) adapted to the needs and in accordance with the applicable standards and
rules.
— To avoid electromagnetic interference, electrical connections to the device must be shorter
than 2 meters.
— Power supply plug must be grounded.
— Disconnect the device from the mains before performing any maintenance work.
— Shut off the compressed air supply when working on the pneumatic assembly.
— Do not open a connected device.
— Avoid splashing water on the device.
E-XTEQ is at your disposal for any information concerning the use of the device under maxi-
mum safety conditions.
We draw your attention to the fact that E-XTEQ cannot be held responsible for any accident
related to a misuse of the measuring instrument, the workstation or non-compliance of the in-
stallation with safety rules.
In addition, E-XTEQ declines any responsibility for the calibration or the fitting of their instru-
ments that is not done by E-XTEQ.
E-XTEQ also declines any responsibility for any modification (program, mechanical or electri-
cal) of the device done without their written consent.
