34
10. Care and Maintenance - continued
10.7 Fuses
Non-Flash/Beep Code Faults
If the following faults occur, please check the appropriate fuses located inside the power module
panel or at the centre of the tiller. Refer to figures 26 and 27 below for fuse replacement and
warnings.
3SAMP Blade Style Fuse shown
Faults
Figure 26: 35 AMP Power Module Fuse
The dash does not illuminate when the key is turned to the on position. The
Scooter does not operate, and the headlight/ taillight does not illuminate.
The USB charging port will not charge your smart devices such as a phone or
tablet.
Remedy: Check the fuse (35 AMP) inside the power module panel located directly under the seat. Replace the fuse with
the same type and rating if the fuse is bad.
3AMP Mini Glass Fuse shown
Good Fuse
Bad Fuse
Fault
Figure 27: 3 AMP Tiller Fuse
The XLR charging port is not functioning, causing the battery pack not to charge when the
off-board battery charger is connected.
Remedy: Check the fuse (F3AL250V) inside the fuse holder located on the tiller below the control panel. Replace the fuse
with the same type and rating if the fuse is bad.
Fuses MUST be replaced with same type and rating.
Good
Fuse
Bad
Fuse
Содержание PURSUIT
Страница 1: ...1 Owner s Manual Proudly brought to you by...
Страница 32: ...Proudly brought to you by...