H820 User Manual
E-Lins Technology Co.,Limited
Tel: +86-755-29230581 E-mail: [email protected] www.e-lins.com
2.4 SIM/UIM card installed
If your router has SIM/UIM card protector, please remove it, insert the sim card correctly,
and fix the protector.
If your router has no SIM/UIM card protector, please insert the sim card correctly.
Notes:
SIM/UIM card does not reach the designated position, the equipment can not find a card,
can't work normally, therefore inserted a try to check again for a
SIM Card
is stuck fast.
2.5 The installation of terminal blocks
This chapter is for version with terminal blocks only. Default, the H820 is with DB9
connector. Please use DB9 cable to connect H820 and the equipment directly.
The following is for version with terminal blocks only:
H820 uses pluggable terminals to connect the user’s data and the power supply. Spacing:
3.81mm, 2 Pins; User data and power supply suggestion: 14~24AWG. Please refer to the
table 2-4 for the interface definition of the power cable and connection sequence. Specific
interface definition of the power cable and connection sequence you can read on the
labels of H820 products. Using 14~24AWG cable and referring to H820 products labels
or the bellowed interface definition and connection sequence, you need to use the oblate
screw driver to fix the cable to the connecting jacks of the pluggable terminal. After
successfully connection, you need to insert the terminal into the corresponding position in
the bottom of the H820 products.
Notes:
Connection sequence should be accurate
。
Cable’s insulating striping length is
about 7mm. (For safety, insulating striping length should be too long). Please refer to the
picture.
